This is a working overview of ACTH(4-10), written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-09-10 and is reviewed periodically as new material appears.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
Development of the compound took place in the Soviet Union during the 1980s, largely through peptide research groups affiliated with the Shemyakin-Ovchinnikov Institute and Moscow State University. Investigators screened fragments of adrenocorticotropic hormone for activity on the central nervous system while attempting to separate cognitive effects from hormonal ones. The shortened sequence was selected because it retained behavioral activity in animal models without stimulating corticosteroid release. Early publications described the molecule as an ACTH(4-10) analog.
Published research on this peptide originates mainly from Russian laboratories, and the wider international literature is comparatively thin. Studies have used rodent models of stroke, hypoxia, and memory tasks, with a smaller number of human trials reported. Reported outcomes include changes in attention and memory measures, along with effects on neurotrophic factor expression in some experiments. Small sample sizes, inconsistent dosing protocols, and limited independent replication are widely noted limitations, so the strength of the clinical evidence remains an open question.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C37H51N9O10S | Contains one methionine sulfur atom |
| Molecular mass | Approximately 814 Da | Consistent with a seven-residue peptide |
| Appearance | White to off-white powder | Typical lyophilized form |
| Solubility | Freely soluble in water | Also soluble in dimethyl sulfoxide |
| Typical storage | -20 °C, desiccated | Limits methionine oxidation |
Terminology around the compound varies by source. It appears in catalogues and papers as Semax, as the heptapeptide ACTH(4-7)-Pro-Gly-Pro, and under various alphanumeric laboratory codes used by individual suppliers. These names refer to the same sequence but may imply different salt forms, purity grades, or counter-ions. Peptide databases usually list the free base mass, while product descriptions sometimes report acetate or trifluoroacetate salts with a different formula weight. Because naming conventions for research peptides are not standardised across vendors, checking the declared sequence and measured mass is more reliable than relying on a trade name alone.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. Its design combines the ACTH(4-7) core fragment with a C-terminal Pro-Gly-Pro extension, a modification intended to improve stability and prolong activity. The molecule is hydrophilic, carries no lipid chains or glycosylation, and has a theoretical mass just over 810 daltons in its free form. All seven residues are proteinogenic amino acids, so no non-natural building blocks appear in the backbone. A free N-terminal methionine and C-terminal proline define the unmodified parent peptide.
The compound was developed during the 1980s at the Institute of Molecular Genetics in Moscow as part of research on fragments of adrenocorticotropic hormone. Early work examined short ACTH-derived sequences that retained neurotrophic effects while lacking the endocrine activity of the full hormone. Semax entered clinical use in Russia during the 1990s, where it received registration for several neurological indications. Outside that region it remained primarily a laboratory research material rather than an approved therapeutic. English-language literature on it grew more slowly and frequently cited the original Russian studies.
Development took place during the 1980s at institutes of the Russian Academy of Sciences, where peptide fragments of ACTH were screened for cognitive and neuroprotective effects. The compound received regulatory approval in Russia as a nasal preparation, marketed for conditions such as ischemic stroke, transient ischemic attacks, and optic nerve disorders. Registration in other countries has not followed. Most published clinical reports originate from a small number of Russian research groups, and independent replication outside that setting remains limited. The regulatory status therefore differs sharply between Russia and the rest of the world.
Laboratory work points toward modulation of neurotrophic signaling, particularly expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal tissue. Studies also describe effects on monoamine turnover, inflammatory mediators, and oxidative markers. These observations come mainly from animal models and cultured cells, so the causal chain in humans is not firmly established. Whether the reported molecular changes translate into measurable clinical benefit is an open question. Reviews generally present the mechanism as plausible rather than demonstrated.
As a bifunctional molecule, glycine reacts with many reagents. These can be classified into N-centered and carboxylate-center reactions. Glycine functions as a bidentate ligand for many metal ions, forming amino acid complexes. Representative complexes include iron glycinate, copper glycinate, and zinc glycinate. With acid chlorides, glycine converts to the amidocarboxylic acid, such as hippuric acid and acetylglycine. With nitrous acid, one obtains glycolic acid (van Slyke determination). With methyl iodide, the amine becomes quaternized to give trimethylglycine, a natural product:
HMB is believed to reduce muscle protein breakdown in humans by inhibiting the 19S and 20S subunits of the ubiquitin–proteasome system in skeletal muscle and by inhibiting apoptosis of skeletal muscle nuclei via unidentified mechanisms. Based upon animal studies, HMB appears to be metabolized within skeletal muscle into cholesterol, which may then be incorporated into the muscle cell membrane, thereby enhancing membrane integrity and function. The effects of HMB on muscle protein metabolism may help stabilize muscle cell structure. One review suggested that the observed HMB-induced reduction in the plasma concentration of muscle damage biomarkers (i.e., muscle enzymes such as creatine kinase and lactate dehydrogenase) in humans following intense exercise may be due to a cholesterol-mediated improvement in muscle cell membrane function. HMB has been shown to stimulate the proliferation, differentiation, and fusion of human myosatellite cells in vitro, which potentially increases the regenerative capacity of skeletal muscle, by increasing the protein expression of certain myogenic regulatory factors (e.g., myoD and myogenin) and gene transcription factors (e.g., MEF2). HMB-induced human myosatellite cell proliferation in vitro is mediated through the phosphorylation of the mitogen-activated protein kinases ERK1 and ERK2. HMB-induced human myosatellite differentiation and accelerated fusion of myosatellite cells into muscle tissue in vitro is mediated through the phosphorylation of Akt, a serine/threonine-specific protein kinase.
== PPIs binding mode == The disulfide binding of the inhibitor takes place in the luminal sector of the H+/K+ ATPase where 2 mol of inhibitor is bound per 1 mol of active site H+/K+ ATPase. All PPIs react with cysteine 813 in the loop between TM5 and TM6 on the H+/K+ ATPase, fixing the enzyme in the E2 configuration. Omeprazole reacts with cysteine 813 and 892. Rabeprazole binds to cysteine 813 and both 892 and 321. Lansoprazole reacts with cysteine 813 and cysteine 321, whereas pantoprazole and tenatoprazole react with cysteine 813 and 822. Reaction with cysteine 822 confers a rather special property to the covalently inhibited enzyme, namely irreversibility to reducing agents. The likely first step is binding of the prodrug protonated on the pyridine of the compound with cysteine 813. Then the second proton is added with acid transport by the H+/K+ ATPase, and the compound is activated. Recent data suggest the hydrated sulfenic acid to be the reactive species forming directly from the mono-protonated benzimidazole bound on the surface of the pump.
parameters. Another common practice is to reduce the number of codons by forbidding the stop (or nonsense) codons. This is a biologically reasonable assumption because including the stop codons would mean that one is calculating the probability of finding sense codon
Sources: en.wikipedia.org
== Career == Fischbach was a junior fellow in the Department of Molecular Biology at Massachusetts General Hospital (2007–2009) before joining the faculty of the University of California, San Francisco in 2009. He moved to Stanford University as an associate professor in September 2017. As a Chan Zuckerberg Biohub Investigator, Fischbach is one of eight faculty members across Stanford, UCSF, and the University of California, Berkeley leading the CZ Biohub Microbiome Initiative, launched in 2018, with the goal of understanding how the microbiota can influence human health. Fischbach is currently a member of the scientific advisory board of NGM Biopharmaceuticals and a co-founder of Revolution Medicines.
=== Phytochemicals === Polyphenol phytochemicals present in the fruit, seeds, and leaves are being investigated for their potential biological activities. Major anthocyanins in blackcurrant pomace – delphinidin-3-O-glucoside, delphinidin-3-O-rutinoside, cyanidin-3-O-glucoside, and cyanidin-3-O-rutinoside, which are retained in the juice concentrate – are among other polyphenols.
This process continues until the entire chain is cleaved into acetyl CoA units. The final cycle produces two separate acetyl CoAs, instead of one acyl CoA and one acetyl CoA. For every cycle, the Acyl CoA unit is shortened by two carbon atoms. Concomitantly, one molecule of FADH2, NADH and acetyl CoA are formed.
=== Fruit body production === Italian folklore holds that porcini sprout up at the time of the new moon; research studies have tried to investigate more scientifically the factors that influence the production of fruit bodies. Although fruit bodies may appear any time from summer to autumn (June to November in the UK), their growth is known to be triggered by rainfall during warm periods of weather followed by frequent autumn rain with a drop in soil temperature. Above average rainfall may result in the rapid appearance of large numbers of boletes, in what is known in some circles as a "bolete year". A 2004 field study indicated that fruit body production is enhanced by an open and sunny wood habitat, corroborating an earlier observation made in a Zimbabwean study; removal of the litter layer on the forest floor appeared to have a negative effect on fruit body production, but previous studies reported contradictory results. A Lithuanian study conducted in 2001 concluded that the maximal daily growth rate of the cap (about 21 mm or 0.8 in) occurred when the relative air humidity was the greatest, and the fruit bodies ceased growing when the air humidity dropped below 40%. Factors most likely to inhibit the appearance of fruit bodies included prolonged drought, inadequate air and soil humidity, sudden decreases of night air temperatures, and the appearance of the first frost. Northern Hemisphere plots that face north tend to produce more mushrooms compared to equivalent plots facing south.
Along with what is seen above, other reactive forms of FAD can be formed and consumed. These reactions involve the transfer of electrons and the making/breaking of chemical bonds. Through reaction mechanisms, FAD is able to contribute to chemical activities within biological systems. The following pictures depict general forms of some of the actions that FAD can be involved in. Mechanisms 1 and 2 represent hydride gain, in which the molecule gains what amounts to be one hydride ion. Mechanisms 3 and 4 radical formation and hydride loss. Radical species contain unpaired electron atoms and are very chemically active. Hydride loss is the inverse process of the hydride gain seen before. The final two mechanisms show nucleophilic addition and a reaction using a carbon radical.
Sources: en.wikipedia.org
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.
Most published work uses intranasal administration, matching the route of the registered Russian formulation. Some animal experiments use intravenous or intraperitoneal injection. The route matters because the intact peptide is cleared rapidly from blood, so exposure differs between methods.
A purity value describes the share of the powder accounted for by the target peptide, usually by high-performance liquid chromatography. It does not confirm that the sequence is correct, which requires mass spectrometry or amino acid analysis. Purity and identity are separate checks.
It is a synthetic peptide of seven amino acids. Its backbone corresponds to a fragment of adrenocorticotropic hormone extended at the carboxyl end. The material is distributed as a lyophilized solid for laboratory use.